FO clamp connector F-ST for 200/230µm PCF
This connector, designed for 200/230µm glass fiber uses an assembly without crimping and glueing. A patented clamp system integrated into the connector body holds the PCF fiber, the strain relief and the cable jacket in place after assembly. Also, it is possible to disassemble the connector and reuse it several times. This big advantage makes it easy to repeat an assembly if the demanded optical parameters are failed after finishing. Additionally, there is no need for expensive tools like heat oven or crimp pincers and an enormus time saving while no crimping, glueing and heat cureing is needed. Fiber endface preparation is done by hand thru scribing and breaking or, to get repeatable results, using the special designed fiber cleaving tool from Ratioplast-Optoelectronics.
 |
|
| Connector type |
F-ST |
| Ferrule type |
metal, PCF
|
| Outer diameter |
2.5 mm |
| Inner diameter |
235µm |
Protection class
|
-
|
Assembly type
|
clamping
|
| Accessories |
902SSSTSST001 Dust protection cap red
902KT03250001 Protective rubber sleeve black for cable diameter 3.2mm
910AB00100001 Fiber stripper
910PS0ST00001 Polishing disc
910PB00100001 Polishing film, grain size 1000
910FW230ST001 Cleaving tool for F-ST fiber optic clamp connectors 200/230µm PCF
|
| Data sheet |
 |
| Ordering information |
902SS201STK01
for cable diameter 2.2mm
902SS201STK01-01
for cable diameter 2.2mm without protective rubber sleeve
902SS202STK01
for cable diameter 2.5mm
902SS203STK01
for cable diameter 3.2mm
|
| Additional information |
-
|
